Intellitecmv.com

Battery Guard Tail Lift

Click for larger image.

Tail Lifts are used with the vehicle engine switched off due to environmental directives. The amount of current drawn from the tail lft motor can be substantial and can often result in the vehicle suffering a non-start situation. The Tail Lift Battery Guard prevents this.

KEY FEATURES

• Prevents tail lift from flattening batteries
• Visual and audible warning of low battery condition prior to isolation
• Fully waterproof
• Delphi Packard IP 67 Connections
• Night silent operation
• Can be installed OEM by your lift supplier
• Easy retrospective installation
• Can be used on many types of plant/electro hydraulic equipment

The Tail Lift Battery Guard has been developed specifically to protect the engine starting batteries from being excessively drained by the tail lift, to a point where there is insufficient voltage to start the vehicle.
Using the technology from our other Battery Guard products, the Tail Lift Battery Guard monitors the available battery power when the tail lift is in use. If the battery voltage drops below 24.1V (12.1V), a four minute voltage sensitive timer is triggered on the ECU.

If the voltage remains below 24.1V uniformly for two minutes, the sounder on the ECU will begin to bleep & the LED will begin to flash.  Should the Battery voltage remain below 24.1V for a full four minutes, the Tail Lift Battery Guard will isolate the tail lift, to protect starting voltage.  Once automatic isolation of the tail lift has taken place, the operator must start the vehicle’s engine to restore power to the tail lift, once the Tail Lift Battery Guard senses the charging voltage has gone above 26.2V, the ECU will automatically reset.

All connections are made locally inside the power pack, as a retrospective installation the Tail Lift Battery Guard should take no longer than one hour to install.

Tail Lift Battery Guard is installed inside the pump housing and constantly monitors the available battery voltage. The system provides audible and visual warning of low voltage condition two minutes prior to automatically isolating the tail lift to protect vehicle starting power.

Available as original equipment from Ratcliff, Ross & Bonnyman, Anteo, Dhollandia, and Del. VCA approved to 95/54 EC.

APPROVALS

• Ratcliff
• Ray Smith Group
• Ross & Bonnyman

STANDARDS

E11 10R-021701 e11*72/245*95/54*1701*00

PART NUMBER

Part No	Description	Price
K13	Tail Lift Battery Guard 12v	£105.00	Qty:
K14	Tail Lift Battery Guard 24v	£105.00	Qty: